- New Manley valves
- New Elgin valve springs and keepers
- New Badger pistons
- New Hastings molly rings
- New Dynagear timing gears and Durabond cam bearings
- New Dynagear timing gears and chain
- New Elgin lifters, push rods, rockers, balls and nuts
- New Dynagear oil pump
- New FelPro gaskets
- Cylinder heads are pressure checked
- Diamond honed valve guides
- Three angle cut valve seats
- All head surfaces are broached
- Blocks are bored with deck plates, cylinder walls are diamond honed
- Crankshafts are ground and polished for .002 clearance
- Camshafts are ground to O.E.M. specifications, hardened and polished
- Connecting rods are sized to .002 clearance

Passenger car and light truck long blocks are covered for 7 years or 70,000 miles. If failure of a long block should occur during the first twenty-four months and it is determined the failure is due to a defect in workmanship or parts of the supplied engine, we (Engine Warehouse Inc.) will replace or repair the defective unit to the original buyer. During the balance of the warranty, Engine Warehouse Inc. will replace the long block at one-half of the current retail price.

The Standard limit labor reimbursement covers labor at $35.00 per hour up to a maximum of $400.00. A Premium warranty is offered for $110.00, which pays labor at $55.00 per hour up to a maximum of $700.00. An Extra Premium warranty is offered for $150.00, which pays labor at $65.00 per hour up to a maximum of $850.00.

All Premium and Extra Premium warranties must be purchased at the time of sale.

- Loss of time
- Loss of income or revenue
- Loss of transportation or vehicle rental
- Equipment rental
- Any towing charges
- Crankshaft thrust damage
- Diagnostic time, fluids, filters or shop supplies
- Oil starvation for any reason
- Piston scuffing
- Overheating, melting of heat tab
- Detonation, pre-ignition (melting of pistons)
- Head gasket with burnt fire ring
- Abnormal wear from contaminated oil (fuel or dirt)